The forum for discussing all kinds of brewing paraphernalia.
- Site Admin
- Posts: 9884
- Joined: Sun Aug 22, 2004 1:00 pm
- Location: Washington, UK
Chassyh wrote: ↑
Sat Jan 13, 2018 7:26 pm
Thanks, it may be helpful once I’ve got inside the cylinder. I assume step one is to undo the large nut with the serrated tail on it at the bottom of the cylinder. Is it right or left hand thread? I’m assuming it will be tight?
If my memory is correct, it's a normal right hand thread. And yes, mine was pretty tight - I put the nut in my woodworking vice and turned the BE with my hands.
Who is online
Users browsing this forum: No registered users and 8 guests