Hi all,
Firstly apologies I've not been around for a while. Work and Home Strife but nowt family related.
I've not brewed for almost 3 months and decided it was time to get the brewery back on track.
So........
I have over the last week or so been collecting parts for the below, it based on a 9L Burco Cygnet got for cheap on the bay.
Then whilst SWMBO was putting the little one down this eve I attacked it
Making the holes in the lid with the help of a QMAX punch.
Tweak Tweak, crank, cut, tighten. The long legs on the 8mm are for height adjustment of the coil if need. The T-piece is from BES, 1/2" BSP -> 3mm gland form watch-hill screws into that.
Coil in place:
Inside the Cygnet:
It's air tight, so should be mash liquor tight Testing commences Sunday.
John
HERMS heat exchanger, built awaiting testing
Re: HERMS heat exchanger, built awaiting testing
Great
I particularly enjoyed looking at the image of the cygnet interior.
I particularly enjoyed looking at the image of the cygnet interior.