It's for the port of a 10" filter housing, the male thread looks to be about 3/4", not sure the diameter of the barb but it would fit into a standard syphon...
I know one of you will know
Cheers!
Any idea where i'd find one of these ?
Any idea where i'd find one of these ?
- Attachments
-
- pic.jpg (172.98 KiB) Viewed 1105 times
- mixbrewery
- Drunk as a Skunk
- Posts: 831
- Joined: Mon May 21, 2007 7:48 pm
- Location: Hemel
- Contact:
Re: Any idea where i'd find one of these ?
Is this for your GAC10 water filter housing?
I've used brass 3/4" to 22mm on mine.
This JG valve fits nicely if you need to control the water inlet. It has a 15mm pushfit with 3/4"
I've used brass 3/4" to 22mm on mine.
This JG valve fits nicely if you need to control the water inlet. It has a 15mm pushfit with 3/4"
Check out the beers we have for sale @ Mix Brewery
Re: Any idea where i'd find one of these ?
http://cgi.ebay.co.uk/Hose-Tail-3-8bsp- ... 911.c0.m14
This looks simlar, this guy sells other simlar looking hose barbs, cheap too, ive brought from him with no problems,
hope this helps. kev
This looks simlar, this guy sells other simlar looking hose barbs, cheap too, ive brought from him with no problems,
hope this helps. kev
Re: Any idea where i'd find one of these ?
Guys, that helps a lot, cheers. Hose tail, so that's what they're called. Yeah it is for a water filter housing but I use it to filter lagers.
Re: Any idea where i'd find one of these ?
Is it an American housing? If so it will be NPT not BSP. That said, a load of PTFE tap usually makes them compatible....
Re: Any idea where i'd find one of these ?
Oh yeah, cheers for that Steve.
Is there anywhere that sells NPT fittings here? If not i'll just get the PTFE tape out I suppose
Is there anywhere that sells NPT fittings here? If not i'll just get the PTFE tape out I suppose