element washers
element washers
Hi I am making a plastic boiler with 2.4kw elements from hop and grape, the elements come with 2 washers one soft white one and the other is hard and black. Does anyone know what way round they are meant to go?
- 6470zzy
- Telling everyone Your My Best Mate
- Posts: 4356
- Joined: Sun Jun 14, 2009 7:07 pm
- Location: Cape Cod
Re: element washers
http://www.hopandgrape.co.uk/catalog/de ... LE20206569&
If you check out the picture of the heater element I think that you should see the proper configuration of the 2 gaskets.
Cheers
If you check out the picture of the heater element I think that you should see the proper configuration of the 2 gaskets.
Cheers
"Work is the curse of the drinking class"
Oscar Wilde
Oscar Wilde
Re: element washers
Either your eyesight is far better than mine or you are getting confused by the black and white parts at the rear of the element. the washers I am refering to are about 1mm thick
- 6470zzy
- Telling everyone Your My Best Mate
- Posts: 4356
- Joined: Sun Jun 14, 2009 7:07 pm
- Location: Cape Cod
Re: element washers
My humble apologies I was apparently confused by the pictures appearance. However in general use I would think that the fiber would go on the outside and the rubber on the inside. It seems as though a lot of the lads on this forum use this style of boiler and I am sure that one of them will chime in
Cheers
Cheers
"Work is the curse of the drinking class"
Oscar Wilde
Oscar Wilde