Hi All,
I have a flash chiller that I occassionaly use with my beer engine. The beer line I have is the 1/2" food grade hose pipe stuff that works very well. My only problem is that to date if I have needed to use the chiller I have bodged the connections to it by wrapping the inlet and outlet in electrical insulation tape, forcing the pipe over it and jubilee clipping it (!). It works well but the time has come to buy some proper connections.
I know the inlet and outlet are 3/8". Has anyone any ideas about the best way of connecting the pipe I have to the chiller? I'm thinking pushfit but I'm no plumber so am a bit lost.
All help appreciated.
Flash Chiller Fittings
A
I'm not sure really. My thought is that the fitting will be for 1/2" copper / plastic pipe which will be a lot smaller than the beer line I have which has thick walls. I seem to remember that the outside diameter is something like 17.5mm (the inside diameter being closer to 12.5mm). One thought I had was get a 3/8" to 15mm fitting then force the pipe over a bit of 15mm copper tube. No idea whether it would fit but may be worth a go???
-
- Under the Table
- Posts: 1212
- Joined: Tue Oct 21, 2008 10:14 pm
- Location: North London
Re: Flash Chiller Fittings
I use jubilee clips and no insulation tape for exactly the same purpose and wouldn't consider changing. It's a flawless practice if you ask me.
Planning - Not for a long while
Fermenting - I'm Done
Bottle Maturing - Hobgoblin, Fullers ESB, American Stout, TOP, Fullers London Porter, Bandini Black IPA
Drinking - Still...Whiskey
Fermenting - I'm Done
Bottle Maturing - Hobgoblin, Fullers ESB, American Stout, TOP, Fullers London Porter, Bandini Black IPA
Drinking - Still...Whiskey