Hey folks,
I'm still gathering bits for my single vessel brewery with RIMS and would like to up the safety by fusing the element. Would you trust this fuse holder for a 15a immersion heating element? I'm not so sure...
https://www.ebay.co.uk/itm/5-pcs-x-Pane ... SwPCVX4E74
If you have any suggestions for a better option, i'd love a link! Need to be able to either attach it to the project box or simply have it installed within the box itself. Whatever is cheapest!
Cheers
Would you trust this fuse holder?
- floydmeddler
- Telling everyone Your My Best Mate
- Posts: 4160
- Joined: Mon Feb 16, 2009 10:37 pm
- Location: Irish man living in Brighton
- themadhippy
- Even further under the Table
- Posts: 2951
- Joined: Tue Dec 08, 2009 12:53 am
- Location: playing hooky
Re: Would you trust this fuse holder?
Defiantly not,especially not on mains voltage.The thread on the cap is rather long so a good chance of garbing the shiny bit when you unscrew it .http://cpc.farnell.com/multicomp/ppfh-4 ... dp/FF02303 would be my cheap starting point
Warning: The Dutch Coffeeshops products may contain drugs. Drinks containing caffeine should be used with care and moderation
Would you trust this fuse holder?
How about an MCB if you'll have a fixed panel?
- floydmeddler
- Telling everyone Your My Best Mate
- Posts: 4160
- Joined: Mon Feb 16, 2009 10:37 pm
- Location: Irish man living in Brighton
Re: Would you trust this fuse holder?
Cheers folks. Went for the 'inline' type as it seems most simple.
Re: Would you trust this fuse holder?
As already said; those things are crap an prone to problems in my experience.