Keggle build
Keggle build
I am going to build a new keggle but I need to get this part of the keg . Is this possible? I think I have tried everything . It’s just the top triangle bit
-
- Drunk as a Skunk
- Posts: 996
- Joined: Sat Jul 21, 2012 11:12 pm
- Location: Garden of England
Re: Keggle build
hey, sorry can you explain a bit more exactly what it is you have done and are now trying to do? then we should be able to help no problem
dazzled, doused in gin..
Re: Keggle build
Thanks for the reply , I need to get the top bit of the keg. I think it should come of but I can’t get it off with anything . ISA modified herms system . It was to save drilling a hole .
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Re: Keggle build
A small amount of plastic explosive should do it, all depends on how neat a job your after.
-
- Drunk as a Skunk
- Posts: 996
- Joined: Sat Jul 21, 2012 11:12 pm
- Location: Garden of England
Re: Keggle build
haha yeah it's hard to tell from that picture but if it's the same as one of mine i solved the problem with an anglegrinder
dazzled, doused in gin..
-
- Drunk as a Skunk
- Posts: 996
- Joined: Sat Jul 21, 2012 11:12 pm
- Location: Garden of England
Re: Keggle build
did you get this off in the end?
is it really important to not cut it off? that neck wont support a 2" tri clamp fitting anyways so i'm just wondering if there's a good reason to keep it intact? you can always solder/weld a (4" even) ferrule on yourself and it'll be even better.
is it really important to not cut it off? that neck wont support a 2" tri clamp fitting anyways so i'm just wondering if there's a good reason to keep it intact? you can always solder/weld a (4" even) ferrule on yourself and it'll be even better.
dazzled, doused in gin..