John guest fitting for a npt threaded keg connector.

The forum for discussing all kinds of brewing paraphernalia.
Post Reply
simpleton
Piss Artist
Posts: 105
Joined: Wed Jul 10, 2013 10:14 am

John guest fitting for a npt threaded keg connector.

Post by simpleton » Wed Apr 04, 2018 7:15 pm

I ordered 2 Sankey keg connectors and they have come without BSP threads so my JG connectors do not work. I assume they are npt. Anyone know where I can get them? Into 3/8 beer line.

Cheers
Si

f00b4r
Site Admin
Posts: 1528
Joined: Fri Jul 11, 2014 10:54 pm
Location: Berlin

Re: John guest fitting for a npt threaded keg connector.

Post by f00b4r » Wed Apr 04, 2018 10:43 pm

simpleton wrote:I ordered 2 Sankey keg connectors and they have come without BSP threads so my JG connectors do not work. I assume they are npt. Anyone know where I can get them? Into 3/8 beer line.

Cheers
Si
Where did you order then from?
They usually come in either UK or US size, if the latter then you can use these:

https://www.themaltmiller.co.uk/product ... 8-adapter/

The Malt Miller also sells adapters that you can use instead that allow you to use corny disconnects on the Sankey coupler instead, quite useful if you have a mixed system and also useful to avoid beer showers if you are not yet used to Sankey connecters.


simpleton
Piss Artist
Posts: 105
Joined: Wed Jul 10, 2013 10:14 am

Re: John guest fitting for a npt threaded keg connector.

Post by simpleton » Thu Apr 05, 2018 8:54 am

Ali express as I could not find them here with PRVs. Probably explain it! #-o They defo aren't the same thread as my stype connectors as I have loads of JG fittings for them. Same size, ever so slightly different thread.

f00b4r
Site Admin
Posts: 1528
Joined: Fri Jul 11, 2014 10:54 pm
Location: Berlin

Re: John guest fitting for a npt threaded keg connector.

Post by f00b4r » Thu Apr 05, 2018 2:30 pm

The one i linked should be the right size then.

Fil
Telling imaginary friend stories
Posts: 5229
Joined: Sun Oct 16, 2011 1:49 pm
Location: Cowley, Oxford

Re: John guest fitting for a npt threaded keg connector.

Post by Fil » Fri Apr 06, 2018 1:22 am

bsp and ntp threads are basically interchangable in the range of 1/4"- 1-1/2" afaik, 1/2" are for sure, even in SS..

what you probably have is some 5/8" threads, check with measuring and the wikipedia page on bsp with its useful chart of measurements..
ist update for months n months..
Fermnting: not a lot..
Conditioning: nowt
Maturing: Challenger smash, and a kit lager
Drinking: dry one minikeg left in the store
Coming Soon Lots planned for the near future nowt for the immediate :(

Post Reply