False bottom fittings

[sbond10]

A homebrewer kindly donated me a 9 inch false bottom. But minus the fittings. So what is everyone using to connect theres up.
Tia sean

[Haydnexport]

on mine i use a couple of different setups depending on what vessel im using, goes something like this , either a male female coupler , male end down through the hole and a nut to secure it to the fb , then an elbow and a hose tail. Or if im using the flat bottom pot , a street elbow , male side into the hole then a nut to secure it and a hosetail into the female end. All depends on the height of your outlet tbo.

[sbond10]

on mine i use a couple of different setups depending on what vessel im using, goes something like this , either a male female coupler , male end down through the hole and a nut to secure it to the fb , then an elbow and a hose tail. Or if im using the flat bottom pot , a street elbow , male side into the hole then a nut to secure it and a hosetail into the female end. All depends on the height of your outlet tbo.

Street elbow is what im currently looking at cant find the nuts will keep searching but cheers bud

[LeeH]

https://rover.ebay.com/rover/0/0/0?mpre ... 2879584474

1/2” nut?


Sent from my iPhone using Tapatalk Pro

[sbond10]

https://rover.ebay.com/rover/0/0/0?mpre ... 2879584474

1/2” nut?


Sent from my iPhone using Tapatalk Pro

After i put out that comment out my brain farted and i found that nut after searching hex nut, but before that i could only find big nuts that goes on a bolt if that makes sense