Jim's Beer Kit

Hi, Thanks for your comments, and I am going to go with controlling the pump option, which is what I was leaning towards, but just wanted that extra bit of reassurance.

Thanks Again.

Hi, Though I have done a search through this forum, but I am still not 100% sure of the best way of controlling a Maxi 110 to keep my 40lt Brite Tank at an steady cool (lets say 10 Deg C) temperature, plus a crash cool to circa 2 Deg C? From my research it appears that some recommend using an Inkbir...

Yes, to fit a 1/2" BSP fitting. Thanks.
Also, I haven't got a proper pipe bender.

Hi, I am after a 1/2" SS pipe Whirlpool Arm (circa 350mm long) for by Kettle Pot, and though I can get one from the Brewpi Shop, but was thinking if there was an UK supplier I could purchase on e from? Though I could make one up in copper, but I would prefer to have one in stainless steel. Any sugge...

Hi, Thanks for your replies. Thought I still plan to purchase my base malts in 25kg pre-crushed bags (I tend to go through 25k every 6 weeks or so). However, my main purpose for a Grain Mill is for the smaller quantities of special malts (Crystal etc.) which I tend to experiment with various varieti...

Hi, I am looking for a Grain Mill and the MM 3 Roller version look good. Therefore has anyone a recommendation on which Mill I should go for?

Thanks.

BeerSmith for me!


Sent from my iPad using Tapatalk

Hi Chris, Thanks, it worked with 115200 baud rate. It may be something for other to note. Thanks again all for your help, which is much appreciated.
Kloo


Sent from my iPad using Tapatalk

I read about that, and what rate did you use 9600 or 11500?


Sent from my iPad using Tapatalk

Hi Rad, I have been looking at the Nodemcu-E12e (ESP8266), and I am struggling with adding all the software / firmware onto the board. Therefore, do you have any tips that I need to install the Brewpiless code? Ps. I have various software from Arduino IDE and Nodencu Flasher etc, but cannot get the ...

I use Beersmith and it is brilliant.

Hi All, I am in the process of upgrading my MT from an Igloo to a Bergland 50 lt thermo pot and I should be grateful if you could comment on the best FB I should go for? I have read that the Blichmann FB (15 gal version) in a good option, though a bit pricy, or will a standard perforated holed sheet...

Hi

I read a lot of Brewers here use these elements, but which one of the Backer would you recommend: The SKS 2.75Kw kettle element or the Haden: 2.4Kw Classic Standard Kettle Element?

Thanks for you help.

Hi,

I have read a lot about the benefits to taste by dry hopping, but would like to know which is the best method? Do I added the hops loose or do I place in a muslin bag to avoid the bits when botteling?

Thanks.

Hi All, I am sorry if I am posting a familiar topic, but my plan is to go all gas (propane) in my Brew Shed. Though I appreciate that electric may be a more controllable option, but providing a mew uprated supply will prove to be too difficult. Therefore, what KW rating do I need for a circa 40 Lt b...