Jim's Beer Kit

Look for a 120 mesh I use that for my hop filters which suits pellet hops.

Well the first 4 1/2 gallon went down a treat ,had the Pyatshaw wednesday club meeting here went to fill a couple of bottles for my mate in the morning to take with me and only managed to get two bottles out of the pin "good effort as they say here"

I use my underback from the mash to the Copper with high low level switches to save on hanging over it watching the flow. http://i1170.photobucket.com/albums/r529/scotiasam/Pilot%20brewery/WP_20140608_005_zps7cecc446.jpg http://i1170.photobucket.com/albums/r529/scotiasam/Pilot%20brewery/WP_20140630_...

I use what we call a skinny disk http://www.ebay.co.uk/itm/Klingspor-thin-metal-cutting-discs-115-x-1mm-stainless-steel-GRP-slitting-disc-/181164853142?pt=UK_Home_Garden_PowerTools_SM&var=&hash=item2a2e444796 I find for best results score the metal first with the cutting disc along the line to be cu...

Get rid of the wife is another option!

LeeH wrote:Hoping to finish the plumbing this week.

Hi Lee,

have you thought about flushing the flux from the pipe with hot water before use..? You dont want that in your filter.

Try less holes and smaller as you suggest. http://i1170.photobucket.com/albums/r529/scotiasam/Pilot%20brewery/th_WP_20140623_003_zps19d63b00.jpg I only did my first brew on Monday but that was over two hours and transfering 10ltr of water each time, allow to stand for 15mins draw off into the underb...

15mm copper capped, series of 1.5mm holes for the sparg arm inserted into a 15mm T tighten. For the inlet tighten the olive with a small piece of 15mm copper and screw back untill rotating freely then a wee blob of solder to stop the nut undoing its self then attach which ever fitting you are using ...

mixbrewery wrote:It gives you that warm fuzzy feeling inside seeing that first brew on the new kit.
First class build mate
Hope the Porter turns out ok.

Cheers! have not seen Ogri in a long time.

Cheers again Lee,

I found when I switched the panel off then back on and started the cooler again it was pulsing upto a certain point then run on continuously after a short period . I did not get exactly how long as I had headed into the house and when I returned it was running.

One last thing would this also work to stop the heater pulsing?

Sam

Also see the auto tune feature on column 2 page 2 under NOTES. This should get the PID terms as close as you need it. Just follow the instructions and leave the tune on until it controls well. This may take 30mins or so. Cheers Lee, Before I set the auto tune mode I changed the d mode to 1 instead ...

Still does not make sense to me I can weld but electronics baffle me, here is a link to a copy of the manual could you have a look please?

http://www.agptek.com/download/PC17-user-manual.pdf

I am having trouble getting the Mypin T series controller set properly, does anyone know of the setting to stop the controller pulsing on the heating side and also on the cooling side?

Having trouble getting the Mypin T series controller set properly, does anyone know of the setting to stop the controller pulsing on the heating side and also on the cooling side?

Sam