Does such a thing exist

[SamT]

As 7/16 to 3/16 JG speed fit connectors?

I've got the 7/16 to 3/8 connectors attached to the disconnects on my cornies but I think I'm going to need to step this down to 3/16 to balance pressure. It'd be a lot easier if I could just go straight to 3/16 off the disconnect itself

[Nosferatu]

Best place to check would be a plumbing or pipe fittings site . Seems an unusual size though . http://www.plumbcenter.co.uk/en/plumbin ... c-fittings

[keith1664]

The answer is no, You can either have 1/4" FFL to 3/8" pipe or to 5/16" pipe. (1/4" FFL = 7/16" UNF)

http://www.johnguest.com/product/inch-s ... fl-thread/

You then need one of these to step it down.

http://www.johnguest.com/product/inch-s ... nnector-2/

[byronb]

I think you should be able to step it down with a reducer instead of a straight connector. Removes the need for a short piece of 3/8" pipe.

http://www.johnguest.com/product/inch-s ... reducer-3/