Party pump for cornelius keg

Will333 · Post by **Will333** » Fri Jul 15, 2016 3:14 pm

Is there anywhere in England that sells pumps for kegs? They sell them in the states but the postage is about 50 quid. Would be really useful for parties.

Rogermort · Post by **Rogermort** » Fri Jul 15, 2016 10:15 pm

These are quite useful for party dispensing
https://www.brewbuilder.co.uk/co2-mini-regulator.html

Sent from my iPad using Tapatalk

Will333 · Post by **Will333** » Wed Aug 10, 2016 3:52 pm

Is this one much worse?

http://www.ebay.co.uk/itm/Party-keg-pic ... Sw~oFXKac5

Useful to have the disconnects and tap too!

Can small amounts of gas be discharged at once? Or will it unload the whole lot at once?

Coffeeuk · Post by **Coffeeuk** » Thu Aug 11, 2016 8:37 am

There available through Amazon but there £130 delivered.

Lever Handle European Sankey Keg Party Pump - 8 Inch Steel Barrel by KegWorks https://www.amazon.co.uk/dp/B013S2JJXU/ ... RxbZVFTYJ0

Will333 · Post by **Will333** » Thu Aug 11, 2016 8:44 am

Do they exist for corni kegs?

I haven't found them anywhere so I've been looking at the chargers..

Coffeeuk · Post by **Coffeeuk** » Thu Aug 11, 2016 8:51 am

Oh yes, didn't see the corny keg bit. Still early for me lol

I haven't seen them for cornys. You could just make one easily enough with a bike pump I suppose.

Will333 · Post by **Will333** » Thu Aug 11, 2016 2:15 pm

And if I went for the charger - is there much difference in quality between the two links above?

Secla · Post by **Secla** » Thu Aug 11, 2016 3:36 pm

I was recently looking for a mobile option and went for a soda stream cylinder with an adapter to fit regular keg
Soda stream gas can be picked up from anywhere and the bigger cylinder is more cost effective than the small 1 use things

bigtoe · Post by **bigtoe** » Thu Aug 11, 2016 11:45 pm

Just add a stainless schrader valve to the lid something like this...http://www.ebay.co.uk/itm/Rota-alloys-S ... Sw7NNT2R5X

Then all you need do is pump with a bike pump and use a party tap...just make sure to sup the beer in a day or 2.

I have them on my kingkeg top tap lids, i use them to allow gas out to set pressures easy but have also used them with a bike pump at parties to serve the beer, and when i use the keg to serve beer line cleaner so i don't waste co2.

Or look for an adaptor from a bike pump to gas in connector so all you need do is add a few pumps and the pressure is back up enough to serve.

steveshep8676 · Post by **steveshep8676** » Thu Aug 11, 2016 11:56 pm

[IMG]//uploads.tapatalk-cdn.com/2016081 ... 6bfa6a.jpg[/IMG]

I sell these if your looking for that kind of thing? They're stainless steel 5 litrer volume with a co2 cartridge attachment to pressurise the growler.
Email steveshep1@btinternet.com for more information

Jim's Beer Kit

Practical Homebrewing

HomeBrew Forum

Sponsored by BREW-SCHOOL