Everything beer engine, polypins, cask and questions

A forum to discuss the various ways of getting beer into your glass.
User avatar
LeeH
Under the Table
Posts: 1705
Joined: Wed Jan 11, 2012 9:42 pm
Location: North Lincs
Contact:

Re: Everything beer engine, polypins, cask and questions

Post by LeeH » Tue Dec 31, 2019 6:45 pm

It’s that super tight head keeping it in.


Sent from my iPhone using Tapatalk Pro
To monitor my latest fermentation 27/10 click here
To view my new AG build click here
Keg 1: Berliner Weisse
Keg 2: APA
Keg 3: Stout (Nitro)
Keg 4: Empty

User avatar
PeeBee
Lost in an Alcoholic Haze
Posts: 671
Joined: Thu Jan 21, 2016 2:50 pm
Location: North Wales

Re: Everything beer engine, polypins, cask and questions

Post by PeeBee » Wed Jan 01, 2020 2:07 am

WalesAles wrote:
Mon Dec 30, 2019 9:15 pm
Trefoyl wrote:
Sun Dec 29, 2019 2:47 am
39040914-171A-4260-9362-C6FDA337DDDC.jpeg
Nice looking Beer there Tref!
How do you stop it falling out of the glass when it is on its` side? =D>

WA

Sent from my non torking tap.
"On its' side", looks perfectly the right way up to me.

… hang on, what day is it? Ah …

(Can someone help me off the floor please?)

Binkie Huckaback
Steady Drinker
Posts: 43
Joined: Fri Jul 13, 2018 8:13 pm

Re: Everything beer engine, polypins, cask and questions

Post by Binkie Huckaback » Fri Jan 10, 2020 10:03 pm

Polypins are great because of the time saved instead of bottling, but I always felt the few litres I did bottle because I always brewed 23 litres tasted better than that from the polypin. As you're probably aware, the smaller the quantity, the quicker it comes into condition. Anyway, my set up is as short a piece of tubing as possible off the dispense nipple of the engine; then a John Guest 'Y' piece with two valves. Then as long a piece of hose as you need to get to your cool box containing the polypin. It goes through the drain in the box and fits onto the tap on the polypin. There may be a small hole in the body of the tap (I think to allow air in, as liquid flows out). Put a piece of tape over it. A freezer pack on top of the polypin where the tap is cools the beer to cellar temperature.

Attached to the spare valve on the 'Y' piece, a piece of hose long enough to get to the bottom of a 5 litre water bottle. This allows you to turn off the beer, then flush the line through between sessions.

It was pretty successful as long as you turned the tap of the polypin off, but you still need to get through the beer in under a week as polypins are permeable. Which is a shame, because they're ideal for serving beer via a handpump.

Post Reply