Hi all
Does anyone know the size of the pipe that pushes onto the barb of a party tap? The other end of it goes into a push fit. I'll try to measure it tomorrow but if anybody knows in advance I'd be grateful.
I've sprung a leak by the way so need to cobble something together asap
Cheers Tom
Party tap barb to push fit pipe
- soupdragon
- Under the Table
- Posts: 1686
- Joined: Wed Sep 02, 2009 2:54 pm
- Location: Wirral
Re: Party tap barb to push fit pipe
If you are using a Cornie a better solution is to connect a beer tap with flow control to a beer out connector.
"You're not drunk if you can lie on the floor without holding on." Dean Martin
1. Life is not a journey to the grave with the intention of arriving safely in a pretty and well-preserved body, but rather to skid in sideways, thoroughly used, totally worn out and loudly proclaiming... "f*ck, what a trip
It's better to lose time with friends than to lose friends with time (Portuguese proverb)
Be who you are
Because those that mind don't matter
And those that matter don't mind
1. Life is not a journey to the grave with the intention of arriving safely in a pretty and well-preserved body, but rather to skid in sideways, thoroughly used, totally worn out and loudly proclaiming... "f*ck, what a trip
It's better to lose time with friends than to lose friends with time (Portuguese proverb)
Be who you are
Because those that mind don't matter
And those that matter don't mind
- soupdragon
- Under the Table
- Posts: 1686
- Joined: Wed Sep 02, 2009 2:54 pm
- Location: Wirral
Re: Party tap barb to push fit pipe
With a balanced system I find that party taps work well enough. What would you say is the benefit of a flow control tap over a balanced line?
Cheers Tom
Cheers Tom
Re: Party tap barb to push fit pipe
1/4” ID tubing on mine. A short length of 3/8” John Guest tubing to a 3/8-3/16 reducer.
- soupdragon
- Under the Table
- Posts: 1686
- Joined: Wed Sep 02, 2009 2:54 pm
- Location: Wirral
Re: Party tap barb to push fit pipe
Brilliant, thanks
Cheers Tom
Cheers Tom
Re: Party tap barb to push fit pipe
Yeah I like them. They make a good bottling device too.soupdragon wrote: ↑Wed May 01, 2024 7:59 amWith a balanced system I find that party taps work well enough. What would you say is the benefit of a flow control tap over a balanced line?
Cheers Tom