Nitro handle
Nitro handle
Does anyone know where I can get just the top part of this tap, the handle screw piece, mines just one solid handle and I would like to use my homemade ones ? cheers all
-
Fil
- Telling imaginary friend stories
- Posts: 5229
- Joined: Sun Oct 16, 2011 1:49 pm
- Location: Cowley, Oxford
Re: Nitro handle
Its a fair bet that the thread is either BSP/NTP (very similar upto circa 1" iirc) Or a Metric standard.
I would check out BSP first https://en.wikipedia.org/wiki/British_S ... read_sizes
very handy table there
once the correct sized nut has been identified you can epoxy one into the base of your home made tap handle (fill the nut centre with blutack or wax or something before epoxying and remove once the epoxy has set to avoid fouling the thread)..
I would check out BSP first https://en.wikipedia.org/wiki/British_S ... read_sizes
very handy table there
once the correct sized nut has been identified you can epoxy one into the base of your home made tap handle (fill the nut centre with blutack or wax or something before epoxying and remove once the epoxy has set to avoid fouling the thread)..
ist update for months n months..
Fermnting: not a lot..
Conditioning: nowt
Maturing: Challenger smash, and a kit lager
Drinking: dry one minikeg left in the store
Coming Soon Lots planned for the near future nowt for the immediate
Fermnting: not a lot..
Conditioning: nowt
Maturing: Challenger smash, and a kit lager
Drinking: dry one minikeg left in the store
Coming Soon Lots planned for the near future nowt for the immediate
Re: Nitro handle
Yeah , there the inserts I use , might have to buy the whole tap to use top bit 