John guest fitting for a npt threaded keg connector.

[simpleton]

I ordered 2 Sankey keg connectors and they have come without BSP threads so my JG connectors do not work. I assume they are npt. Anyone know where I can get them? Into 3/8 beer line.

Cheers
Si

[f00b4r]

I ordered 2 Sankey keg connectors and they have come without BSP threads so my JG connectors do not work. I assume they are npt. Anyone know where I can get them? Into 3/8 beer line.

Cheers
Si

Where did you order then from?
They usually come in either UK or US size, if the latter then you can use these:

https://www.themaltmiller.co.uk/product ... 8-adapter/

The Malt Miller also sells adapters that you can use instead that allow you to use corny disconnects on the Sankey coupler instead, quite useful if you have a mixed system and also useful to avoid beer showers if you are not yet used to Sankey connecters.

[simpleton]

Ali express as I could not find them here with PRVs. Probably explain it! They defo aren't the same thread as my stype connectors as I have loads of JG fittings for them. Same size, ever so slightly different thread.

[f00b4r]

The one i linked should be the right size then.

[Fil]

bsp and ntp threads are basically interchangable in the range of 1/4"- 1-1/2" afaik, 1/2" are for sure, even in SS..

what you probably have is some 5/8" threads, check with measuring and the wikipedia page on bsp with its useful chart of measurements..