Hi
I've just stripped my EWL beer engine down to see what might be causing beer to flow back down the pipe after each pull. When I removed the bottom part of the cylinder, I found that the non-return valve wasn't seating properly and it looks like this might be the culprit:
IMG_0412 by Paul Mead, on Flickr
I'm assuming that the o-ring is supposed to fit snugly in the groove, is this right? Any idea where I can get the right one?
Thanks
O-ring on beer engine doesn't look right
Re: O-ring on beer engine doesn't look right
Any idea where I can get the right replacement?
Re: O-ring on beer engine doesn't look right
I was hoping to find somewhere I could order online - the EWL online store only works with Internet Explorer and in any case doesn't seem to cater for the general public. Guess I could email them...
-
- Lost in an Alcoholic Haze
- Posts: 509
- Joined: Sun Aug 12, 2012 12:34 pm
- Location: Hampshire
Re: O-ring on beer engine doesn't look right
you could try Colin Farrell brewery supplys google them
they do beer engine bits
they do beer engine bits