co2 cylinder???

The forum for discussing all kinds of brewing paraphernalia.
Post Reply
craggy

co2 cylinder???

Post by craggy » Fri Jun 23, 2006 7:43 pm

got myself a co2 refill last week and have use it a few times, being lazy once i have put a squirt into the barrel i undo it a few turns but leave it on the barrel loose, just went to use it and it empty?? would it be that its been stored vertical or is it faulty?
i dont think the valve was in conact with the barrel at all....

craggy

Post by craggy » Fri Jun 23, 2006 8:14 pm

cheers for that ill make sure its off in future. :bonk

craggy

Post by craggy » Fri Jun 23, 2006 8:18 pm

could have sworn i put this in the brewing equipment section??? turbo strikes again.....

craggy

Post by craggy » Sat Jun 24, 2006 4:47 pm

cheers daab

i got a new one today so hope it lasts longer....

Steeev

Post by Steeev » Mon Jun 26, 2006 10:21 am

Hi Craggy.

I use the S20 cylinder ( a smaller version of the S30) and I was told by the HBS owner just to run it under a hot tap for a few seconds after using it, as they can tend to leak out occasionally.

Frothy

Post by Frothy » Mon Jun 26, 2006 1:09 pm

its all about the soapy water test :)

Steeev

Post by Steeev » Mon Jun 26, 2006 2:13 pm

You can't beat a good soapy!

Post Reply