Can anyone tell me what thread is needed to screw on a hose adapter to coper tube.
I assume it is 22mm diameter, but is it possoble to buy the threaded part to solder on a hose adapter.
Cheers.
IC Hose fitting question
IC Hose fitting question
Fermenting:Smash AG with Brambling X
Conditioning:
Drinking:
Conditioning:
Drinking:
Re: IC Hose fitting question
22mm x 1/2” female.
https://www.screwfix.com/p/compression- ... mm-x/89654
Sent from my iPhone using Tapatalk Pro
https://www.screwfix.com/p/compression- ... mm-x/89654
Sent from my iPhone using Tapatalk Pro
Sabro Single Hop NEIPA 25/02/20 CLICK ME to monitor progress with Brewfather & iSpindel
-
- Lost in an Alcoholic Haze
- Posts: 677
- Joined: Tue May 05, 2015 11:21 am
Re: IC Hose fitting question
Or you can put 10mm ID vinyl tube around the copper, and 12mm/ 1/2” ID tubing around that.
You will need lots of hose clips, well tightened.
You will need lots of hose clips, well tightened.
- Kev888
- So far gone I'm on the way back again!
- Posts: 7701
- Joined: Fri Mar 19, 2010 6:22 pm
- Location: Derbyshire, UK
Re: IC Hose fitting question
It depends entirely on the diameter of your tube and the thread of your hose connector; there are different types. Though I've not seen many ICs made out of 22mm copper..
Kev