Has anyone any recommendations for a uk sourced corded 1/2 inch variable speed drill that would have enough tourqe at low revs to drive this mill… a google search brings up a plethora of drills… inc percussion… hammer etc… but really confusing to me
My current 3/8 Bosch corded drill isn’t up to the task and I would welcome any advice from somebody using a similar set up
Thanks
Ger
Drill for MM3 pro
Re: Drill for MM3 pro
I would be inclined not to use a drill at all - they are not designed for such operation. A 1/3 hp electric motor and pulley is likely to be a better option, but it means deciding on the RPM needed ( I would reckon 180 rpm)and then working out the pulley sizing for the motor and mill. I know it is a pfaff but it will be a better operation in the long run. It is possible to buy such a motor and gearbox on eBay for about £170.
Re: Drill for MM3 pro
Thanks… I will check it out
Re: Drill for MM3 pro
Any half decent corded drill 800w or above should be fine. More useful, much safer and takes up less space than a motorised pulley system. I use one on my MM2.
More than enough power for an MM3 Pro. There's usually good new prices somewhere like Screwfix or Toolstation. If you go down the used route, get something reconditioned by a reputable seller.
More than enough power for an MM3 Pro. There's usually good new prices somewhere like Screwfix or Toolstation. If you go down the used route, get something reconditioned by a reputable seller.
Re: Drill for MM3 pro
I have a battery 18V DeWalt brushless drill and it works fine on my Bulldog mill; it has a pressure trigger on the drill so that you can adjust its action. A motorised mill is probably better in theory and lots of manufacturers are bringing out motors or fully motorised mills (Kegland/Grainfather/SS Brewtech) but given the few minutes it gets used on occasion I have never been tempted to replace my setup as it works fine and I get a good crush (I do mill slowly though using the pressure trigger).