Hi, i'm currently using Youngs sterilising solution although plan to go the no-rinse route soon enough.I've got a batch of bottles to do but both my fv's are full which means I can't do my usual soaking.I was thinking would it be possible to make up a spray of solution and give each bottle a spray, leave it for a while followed by a good rinsing?
I read alot about no-rinsers various contact times but have not seen any for their traditional counterparts so i'm wondering, would this be sufficient?
Cheers
Young's - Contact or Soak?
-
Wooderson
Re: Young's - Contact or Soak?
Cheers, I thought I read on here with regards to contact time that 20 minutes was inaccurate, and more to do with the constraints of the test? Can anyone shed some light on this?
-
Aleman
- It's definitely Lock In Time
- Posts: 6132
- Joined: Sun Jun 03, 2007 11:56 am
- Location: Mashing In Blackpool, Lancashire, UK
Re: Young's - Contact or Soak?
The FDA 'standard' effectiveness test for 'sanitizers' specifies a contact time of 20 minutes before the effectiveness is 'tested' . . . for that reason many (most) of the recommendations of US Sourced products state a 20 minute contact time . . . even if the effect is instantaneous
-
Wooderson
Re: Young's - Contact or Soak?
Cheers for the advice, ended up leaving them overnight as i'd forgotted to take a hydro reading and couldn't bottle.