Cleaning mini-keg video

The place to discuss all things about brewing hygiene!
Post Reply
User avatar
jmc
Even further under the Table
Posts: 2486
Joined: Thu May 13, 2010 11:43 pm
Location: Swaledale, North Yorkshire

Cleaning mini-keg video

Post by jmc » Thu Jun 13, 2013 12:31 am

I've got a couple of mini kegs and while handy for parties / gatherings I'm worried about storing them empty. Especially as I'm banished to garage brewery. I found this on YouTube and thought it might help others too.

Cleaning mini-keg on youtube

User avatar
OvenHiker
Piss Artist
Posts: 273
Joined: Thu Oct 11, 2007 3:26 pm
Location: South Cambs. UK

Re: Cleaning mini-keg video

Post by OvenHiker » Thu Jun 13, 2013 8:50 am

Good clear advice in that vid. Pretty much what I've been doing to clean my mini-casks. The advice about cleaning after emptying and again before filling is sound.

I'd be wary of using tools to pull out the bung though. It might damage the surface which will rust. Simply pull the red plastic out of the bung before prising the bung out with your fingers.

It also makes sense to keep the outside of the cask clean while in use. Wipe down any froth with sanitised cloth. And spray down tap with sanitiser after each session.
Drinking:
Storing:
Conditioning:
Fermenting:
Planning: ...to finish building new brewery!

User avatar
jmc
Even further under the Table
Posts: 2486
Joined: Thu May 13, 2010 11:43 pm
Location: Swaledale, North Yorkshire

Re: Cleaning mini-keg video

Post by jmc » Thu Jun 13, 2013 10:56 am

OvenHiker wrote:Good clear advice in that vid. Pretty much what I've been doing to clean my mini-casks. The advice about cleaning after emptying and again before filling is sound.

I'd be wary of using tools to pull out the bung though. It might damage the surface which will rust. Simply pull the red plastic out of the bung before prising the bung out with your fingers.

It also makes sense to keep the outside of the cask clean while in use. Wipe down any froth with sanitised cloth. And spray down tap with sanitiser after each session.
I agree about using tools.
I reuse the seal at the top so I don't use tools. I just remove red-parts, then soften up seal by pouring boiling water on top, waiting for it to cool then remove by hand.

After final rinse with boiling water I tried the CO2 purge method from the video which worked well.
It both dried off the last few drops and provided a hostile atmosphere for bugs.

Post Reply