Ferment in a Kilner Drinks Dispenser

Discuss all aspects of fermentation
Post Reply
User avatar
privatewiddle
Tippler
Posts: 20
Joined: Mon Jul 04, 2011 3:20 pm
Location: Cork

Ferment in a Kilner Drinks Dispenser

Post by privatewiddle » Sat Jan 26, 2019 12:27 am

Hello!

I was wondering if there's any reason I could not use a glass drinks dispenser to ferment in. Apart from the rather high tap and the need to make sure not to seal it?
kilner.jpg
The spigot looks like its chrome but is actually plastic.

Any thoughts would be appreciated

TheSumOfAllBeers
Lost in an Alcoholic Haze
Posts: 609
Joined: Tue May 05, 2015 11:21 am

Re: Ferment in a Kilner Drinks Dispenser

Post by TheSumOfAllBeers » Sat Jan 26, 2019 9:01 am

I think you will have a problem with the seal.

It will either seal very effectively or leave too much of a gap.

It’s common enough to leave a fermenter slightly open during main fermentation and seal it with an airlock once you are close to fully attenuated, and you have no such option here

User avatar
vacant
Under the Table
Posts: 1935
Joined: Mon Aug 20, 2007 5:39 pm
Location: downstairs
Contact:

Re: Ferment in a Kilner Drinks Dispenser

Post by vacant » Sat Jan 26, 2019 10:16 am

If the small volume suits your requirements, it will be fine. Remove the orange seal.

I bought airlocks when I started brewing but if I use them these days, it's only because I like the sound. As soon as the yeast start working there is a positive pressure from the gas in a covered fermenter, difficult for anything to drift in that the relatively massive amount of yeast can't out-compete. A while after, the beer is even better protected by krausen. When that dies down the alcohol kills off lots of stuff.

Wilko's equivalent £6 though I ferment a lot in one of their 80 ltr plastic storage containers. They're selling a 14 ltr for £2 at the moment (check the food safe symbol).
I brew therefore I ... I .... forget

Robwalkeragain
Hollow Legs
Posts: 357
Joined: Tue Jun 05, 2018 9:19 am

Re: Ferment in a Kilner Drinks Dispenser

Post by Robwalkeragain » Sat Jan 26, 2019 11:44 am

Chrome plated tap isn’t the best material for fermenting on..

Post Reply