pH question
pH question
I am hoping to brew tomorrow, and have boiled the water, added calcium sulphate and magnesium sulphate as per Camra Classic European beers book.I measured the pH and found it 6.8.Is this too high to brew with, how do I lower it, and does it make that much difference.I have been planning my brew for a few days now and am really looking forward to it, its Fullers ESB
- mixbrewery
- Drunk as a Skunk
- Posts: 831
- Joined: Mon May 21, 2007 7:48 pm
- Location: Hemel
- Contact:
Depends on the type of brewing - mash v extract?
Full mash would benefit from a ph of 5.2 but an extract brew can take a highly ph.
Couple of solutions if you're mashing - use a ph leveller called 5.2, guess what this does?
..or try lactic acid in small doses to lower the ph closer to the magic 5.2
Full mash would benefit from a ph of 5.2 but an extract brew can take a highly ph.
Couple of solutions if you're mashing - use a ph leveller called 5.2, guess what this does?
..or try lactic acid in small doses to lower the ph closer to the magic 5.2
Check out the beers we have for sale @ Mix Brewery
I'll second what Daab said. It is the pH of the mash, not the water, that is most important. The residual alkalinity of the water combined with the action of the mash will hopefully yeild a pH of 5.2-5.5. For a standard type ale like an ESB the majority of waters will work OK. Go ahead and brew with it. Chances are beer will happen. When you are ready for further investigation the link below is a good starting point.
http://www.allaboutbeer.com/homebrew/water3.html
http://www.allaboutbeer.com/homebrew/water3.html