Wherry
Wherry
Just started the Wherry going. Bit concerned about the yeast.
I rehydrated it in water which was about 30 degrees~ (not even warm really to the touch)
It just kind of sank and didn't froth at all like the other yeasts i've made up. I "COULD" see bubbles raising from it by the time i came to add it.
Think it will be ok? I've got the wort in the bin next to a radiator a small bar heater now to get it going.
Further more if the yeast is dead is it possible to repitch another packet at this point?
I rehydrated it in water which was about 30 degrees~ (not even warm really to the touch)
It just kind of sank and didn't froth at all like the other yeasts i've made up. I "COULD" see bubbles raising from it by the time i came to add it.
Think it will be ok? I've got the wort in the bin next to a radiator a small bar heater now to get it going.
Further more if the yeast is dead is it possible to repitch another packet at this point?
I added the yeast, stirred vigoursly. An hour later on a white layer has formed on the top, very thin but it looks like its working 
Everytime thus far ive done a kit ive been on business the day after and not seen it for a couple of days. Im probably just overreacting and expecting a yeasty head to LEAP out at me

Everytime thus far ive done a kit ive been on business the day after and not seen it for a couple of days. Im probably just overreacting and expecting a yeasty head to LEAP out at me

It should take around 12-24 hours to get a good yeast head going, depending on fermentation temp.
Lower temps around 18-20'c would take nearer 24 hours maybe, warmer fermentation around 23-25'c will probably get a good yeast head nearer 12 hours.
The lower temp though, is regarded to give a better beer.
Lower temps around 18-20'c would take nearer 24 hours maybe, warmer fermentation around 23-25'c will probably get a good yeast head nearer 12 hours.
The lower temp though, is regarded to give a better beer.
Your yeasties are pretty quick off the mark there. What temp are you fermenting at? I hope you haven't still got it next to the radiator, as that may be why it's so quick, fermentation temps could be a bit high making the yeasties a bit too hyper...
I usualy leave my fermenter at room temp on the kitchen work top, which seems to keep fermentation stable at around 20-22'c.
I usualy leave my fermenter at room temp on the kitchen work top, which seems to keep fermentation stable at around 20-22'c.
Suppose got to have a bad batch sooner or later...
It is still bubbling away now though even though most of the head is gone.
By the way i see you mention safale alot. Whats special about it?
A lot better than regular ale yeast?
And also you say it might not work yet. Is that because of the Woodfordes yeast reputation? :/
It is still bubbling away now though even though most of the head is gone.
By the way i see you mention safale alot. Whats special about it?

And also you say it might not work yet. Is that because of the Woodfordes yeast reputation? :/
Measured the gravity of the wherry. Started it at about midday on Saturday. It was 1.040 to begin. Now it's got to 1.020.
Is this bad? Sounds quick.. I did get off to a very fast start as it was quite warm in the room at the time. I have a couple of packs of youngs yeast if need be..
I have the sterilised hydro floating in it now permantly and will check again in a day or 2.
Is this bad? Sounds quick.. I did get off to a very fast start as it was quite warm in the room at the time. I have a couple of packs of youngs yeast if need be..
I have the sterilised hydro floating in it now permantly and will check again in a day or 2.
Watching this with interest......... on the subject of yeast pitching, I put in plenty of air into the mix with a paddle attached to my drill and that works a treat but now I am unsure as to whether I should just pour the yeast in and leave it or whether I should be stirring the yeast in. Sorry I wasnt trying to take over this thread but I thought it might be relevent. Oh I should mention I have re hydrated the yeast off in a seperate bottle first to get it going.